Diese Website speichert ausschließlich technisch notwendige Cookies.
Datenschutzerklärung

MF 
DACHDESIGNER

MF DachDesigner draws roof models and uses them to calculate the roof surfaces (measurement certificate). Based on this, wind suction, sloped roof, roof drainage, building physics, etc. can be created.

The Software

dachsoftware mf dach

Intro

With MF DachDesigner you draw technical roof models with real roof superstructures. Instead of lines, you draw wall junctions or roof edges, points become gullies, etc. The roof model forms the basis for technical calculations, such as slope insulation, wind uplift, building physics and roof drainage. The automated creation of measurements and quotations is also possible.

Flat roof planning is done in 6 steps:

  1. Enter address and key data of the building
  2. Draw roof model
  3. Carry out calculations (wind uplift, gradient insulation, building physics, drainage ...)
  4. Yield and profitability of the solar system
  5. Mass calculation (automatic roof area calculation)
  6. Service specifications

Plug-Ins

dachsoftware mf dach

MF Dämmplan

MF Dämmplan takes over the roof models from DachDesigner and creates the slope insulation plan for them. This can then be manually optimized and adapted to customer requirements.

Read More

dachsoftware mf dach

MF Drain

MF Drain creates and optimizes calculations for drainage with gullies and gutters according to DIN 1986 Part 100 and DIN 12056 Part 3. MF Drain is available as a basic and professional version.


dachsoftware mf dach

MF Windsog

When planning flat roofs, their positional stability must be verified. This can be done by a wind uplift calculation according to the rules of the German Dachdeckerhandwerks or according to DIN EN 1991-1-4.

Read More